Home | Support | Inquiry | Career | Contact UsDealers                       
Home > Product > Clearn Room/Pharma/HVAC > Temp RH Indicator And Controller
 
DATASHEET | UT-1405 | CLEAN ROOM TEMP. + DP INDICATOR
 
   Datasheet | Manual
 
Temp. + Room Pressure indicator with integral or remote sensor. External Box : Ex. Flameproof with S S Box
 
Feature:-

► FDA 21 CFR part 11 - GAMP-4 compatible.
► Micro controller based indicator with inbuilt Temperature + RH measurement in single enclosure.
► Incorporates highly stable built-in or Remote Temp.+ RH sensor.
► 3 Digit, 0.56" bright LED display for displaying RH & Temperature.
► Process parameter Hi and Low LEDs. Status indication For both channel.
► User selectable set limits for process value violation.
► Inbuilt buzzer to audible process value violation.
► Password protection for calibration and programming mode.
► Software Calibration for 2 channels.
► MODBUS RTU multi drop RS-485 serial communication for PLC, SCADA, etc.
► Programmable devise address, baud rate, (max no. of device is 1-256).
► Remote programmable from master device.
► User programmable offset correction.
► Compact, All Stainless Steel enclosure with 35 mm depth for installation in prefab panels.
► Brick and modular wall mounting and flush mounting.
► Ex. Flameproof model available for Hazardous applications..

 
FDA 21 CFR part 11 compliance data logging computer software available (SCADA)
 
Technical Specification:-
Input Nos. of input 2 nos .(TEMP + DP)
Temperatures input Integral Or Remote (external)
DP input Integral Or Remote (external)
Transmitter power supply 24V/5V DC @ 30 mA max, isolated from I/p & O/P.
Indication Temperatures Channel-1 : 3 digit Seven segments 0.56” RED display.
DP Channel-2 : 3 digit Seven segments 0.56” RED display.
Status indication 5-LEDs for visual alarms, buzzer for audible alarm, LED for 485-comm.
Range Temperatures 0 to 60.0 *C with decimal point.
DP -10 to 10 mm / -25 to 25mm / -100-100 mm /-200 to 200 mm wc
Display Resolution mm wc : 0.1 / PA : 1 / Hpa :0.01
Accuracy Temperatures 0.25 % on FS                     Response time : 8 sec
DP 1 % on FS in all unit          Response time : 1 sec
Communication Communication Protocol Modbus RTU RS- 485 Isolated communications.
Programmable parameter Baud rate , Parity , Node address , stop bit.
Read /write parameter Read: Process value ,decimal point. Write: Hi Low set point.
No. of slave ID Total 1-256 unit.
Programmable
Parameters
Set point / High scale / Low scale Full range as per input selection.
Programming of parameters Through 4 tactile keys (with password protections)
Alarm logic Full Scale HI OR Full scale Low
Other Mounting Bricks and modules wall Flush panel mounting.
MOC Full S S 316 plate and box , back side wall mounting M S covers.
Supply voltage Power consumption 24 v DC @ 4 watts maximum
Operating ambient temperature and humidity - 0~50 °C -           Below 90%, non condensing
Flame Proof Gas group I IIA IIB as per IS 2148/1981
Enclose certification Enclosure is certifies by C.M.R.I. Dhanbad
Display glass Clear glass thognet type A as per Is 2206
Degree protection IP 65 as per IS 2147
Material of constructions Aluminum alloy
Cable entry 5 x 3/4 “ ET
 
 
Datasheet | Manual